2. analog
  3. 1243253805

Phantom custom mount on SME slot?

I currently have a Graham 1.5T mounted on a VPI TNT using an SME type mount. There is a Phantom with the Graham custom base available to me and I'm trying to determine if the custom base could be used on my current armboard with SME cutout.

Centre of the SME cutout is the same as the custom base ~8.5" from the spindle and width of slot is about 30mm.

Thinking it should be possible to mount over the SME cutout and just drill the new holes required by the Graham base.
This would save me getting a new armboard in the short term.

Wondering if one of the forum's Phantom owners, with Graham custom mounting base, could measure the diameter of the base and the distance between mounting holes?

Also interested in any opinions on whether the Phantom Custom base is better/same as SME mount sound-wise?
128x128tobes
6 responses Add your response
samleung
38 posts
 
It should be ok. I have Phantom tonearm with SME V cutout on VPI TNT. Better check with Graham to make sure the tonearm length for 1.5 and Phantom are the same. I know Phantom has long arm wand. Check your tonearm length.
tobes's avatar
tobes OP
436 posts
 
Phantom, 2.2 and 1.5 all share the same effective length of 235mm.

All I really wanted was the hole spacing on the Graham mount. Someone on another forum has advised the holes are spaced 90 degrees on a 2.200" bolt circle.
This gives about 40mm between hole centres - making it a tight fit over the slot. If bolt nuts are attached it looks like they may slightly overhang the slot. Aesthetics aren't going to be great either, as old bolt holes and some of the SME cutout will be visible.

My best option (of course) is to get the Phantom with the SME mount and avoid any issues.
jcarr
382 posts
 
Note that some Phantoms have longer armtubes, which have been made primarily for use with turntables that have oversize platters. I think that these are 10 or 10.5 inches.

hth, jonathan carr
dgarretson
2,598 posts
 
I have VPI and Graham TNT armboards cut for SME & Graham 2.X respectively. I believe the 2.X pattern is same as Phantom? It's not practical for me to overlay these armboards right now, but I looked at it awhile back. Overlaying the Graham cut-out and drill pattern on top of the SME pattern is feasible but unsightly. The Graham pattern is a 40mm diameter hole encircled by four drill points 40mm apart. The SME pattern is approximately 70mm x 32mm elongated hole with four drill holes at corners 60mm x 42mm. My recollection is that none of the corner holes line up.

You'd probably have better luck starting fresh with a used Graham armboard for about $200 or a piece of 11" x 4" hardwood. Alternatively you could cover the area with a 1/8"- 1/4" brass plate.
hevac1
812 posts
 
Just email Bob at info@graham-engineering.com
Or call him phone: (781) 932-8777.
and ask he will help you.
tobes's avatar
tobes OP
436 posts
 
I've pretty much decided to go for SME mount Phantom. Saves the hassle (and expense) of sourcing a S/H Graham drilled armboard. With the demise of the TNT, armboards no longer appear to be carried by the online retailers either.

Thanks all for the input.
Log in to respond
More to discover
80x80
Kuzma Stabi S
80x80
TriangleART HATHOR
80x80
Lenco L75