Remove the fluid as your manual recommends. The syringe the fluid comes with can also be used to draw most of the fluid out. Cotton Qtips to remove any remaining fluid.
The following is Directly from the Graham manual!
IMPORTANT! During any reshipment or transport of the arm, or if the arm will be tipped over, the fluid MUST be removed, using a cotton swab stick. Carefully scoop out some fluid with the cotton tip and wipe it off onto a paper towel. Repeat this until well is empty.Also wipe off the bearing point in the housing cap. Be carefull not to allow any fluid to drip down between black pivot housing and bearing well as it is difficult to clean silicone fluid from this area.
Read the manuals for proper knowledge and not opinions as the buyer sure would not be pleased having to clean silicone fluid up from his new purchase making it a Negative experience!
Cheers
The following is Directly from the Graham manual!
IMPORTANT! During any reshipment or transport of the arm, or if the arm will be tipped over, the fluid MUST be removed, using a cotton swab stick. Carefully scoop out some fluid with the cotton tip and wipe it off onto a paper towel. Repeat this until well is empty.Also wipe off the bearing point in the housing cap. Be carefull not to allow any fluid to drip down between black pivot housing and bearing well as it is difficult to clean silicone fluid from this area.
Read the manuals for proper knowledge and not opinions as the buyer sure would not be pleased having to clean silicone fluid up from his new purchase making it a Negative experience!
Cheers