2. amps-preamps
  3. 1250819959

Passive Preamp Build; ? on RCA Jack Grounding

I'm starting a build on a small passive preamp. The RCA jacks that I bought have two small insulating washers. One has a shoulder on it. It makes me think that the washer with the shoulder is designed to center the jack in the hole and prevent it from grounding out through the rear panel.

This didn't quite make sense to me since I will be attaching the outer shell of the jack to ground anyway.

Is there a reason to use the washers and to prevent the jack from directly contacting the panel?

Thanks,

Chris
hi4head
4 responses Add your response
hi4head OP
20 posts
 
Great and thanks for the reply. I also have read about a switch to lift the grounds with a capacitor in the series. I figured that if I had some hum issues, then I would go back in and alter the wiring.

I have a lot of copper sheet around due to my other hobby (making copper and silver jewelry) and figured that I'd use some of that to make a star ground. Heck, I might even cut it into the shape of a star just for kicks.

Thanks again,

Chris
ngjockey
1,042 posts
 
Probably won't hurt at all.

I had a switch to lift the grounds, based on other's advice, but found it useless. I smashed flat a piece of copper pipe and screwed all the grounds to that.
hi4head OP
20 posts
 
Thanks Jgjockey.

I was planning to do a point-to-point star ground in this first project.

My take is that it really won't hurt anything if the jacks are grounded to the star and to the rear part of the chassis. Correct?

Thanks,
Chris
ngjockey
1,042 posts
 
To enable star grounding.
Log in to respond
More to discover
80x80
McIntosh MX-110
80x80
KR Audio P135 MC Pre Amplifier w/MC Phono
80x80
Krell Chorus 7200 XD