Owners of BAT phono preamps, need some info....

I think this is the tech sheet.
https://www.te.com/commerce/DocumentDelivery/DDEController?Action=srchrtrv&DocNm=205089&DocT...

I appreciate the info. Are you saying that that is what BAT uses? Thanks!

It's the one you showed a picture of.

yeah. I showed what it looks like it, but I do not know the specs of the original part. 

Another option is Bulgin pins. I’ve used both male and female to construct TX2575 plug-ins for Pass Labs and Atmasphere phono preamps. They use high-quality gold plating over solid copper. They come in 10-packs and three pin diameters. Here are some typical p/n’s at Allied Electronics:

565-0058 SA3350

565-0059 SA3347

565-0060 SA3348

565-6003 SA3349

Thanks.

BAT responded and said they dont carry the pins anymore and didnt have the info. I will stick a wire in there and take a measure with a caliper.

I'll like end up with those Bulgin pins :)

If its the same pins they send for use on the phono cards like the one I installed in my VK-30, you can just insert the leads of the resistor directly instead of using the pins. I felt the solder plus another metal interface to be a disadvantage.