Buy a Project Phono Box (transistor) and run a long IC to your line stage preamp. Any one from Audioquest, Kimber, Monster ... will do just fine! Least costly is fine! Ditto for the phono cable! Paying more DOES NOT bring ANY improvement in SQ (so burn me at the stake!). Keep the Talisman cartridge (a fine choice!). Real SQ improvement is the result of careful alignment of your cartridge (overhang, offset angle, azimuth and vertical tracking angle). Take care of this and don't waste money on fancy wire!
Old Gyrodec and some issues.. Analog Gurus Please chime in!!
Hey All,
I just bought a new-used(very used) Gyrodec w/ Zeta tonearm and Sumiko Talisman Virtuoso (B) cartridge. I am have a couple of issues that I need to solve.
1. Due to limitations of my room the TT will need to be placed about 15 feet from my main preamp/amp. This is a very low output cartridge, I believe like .26 mV. Given this fact is it possible or advisable to run a long interconnect (12-14 feet) from the phono preamp to my main system?
2. I need recommendations for a good phono-stage that can push this tiny signal. My budget for new/used phono stage would be around $500. Or should I look into a good higher output MM cart? Any direction would be greatly appreciated.
3. Recommendations for the tonearm cable (the cable running from the tonearm to the phono stage) It looks to be a 5 pin DIN connection. Budget is $150-ish.
Thanks for your thoughts and advice in advance!!!!
I just bought a new-used(very used) Gyrodec w/ Zeta tonearm and Sumiko Talisman Virtuoso (B) cartridge. I am have a couple of issues that I need to solve.
1. Due to limitations of my room the TT will need to be placed about 15 feet from my main preamp/amp. This is a very low output cartridge, I believe like .26 mV. Given this fact is it possible or advisable to run a long interconnect (12-14 feet) from the phono preamp to my main system?
2. I need recommendations for a good phono-stage that can push this tiny signal. My budget for new/used phono stage would be around $500. Or should I look into a good higher output MM cart? Any direction would be greatly appreciated.
3. Recommendations for the tonearm cable (the cable running from the tonearm to the phono stage) It looks to be a 5 pin DIN connection. Budget is $150-ish.
Thanks for your thoughts and advice in advance!!!!
9 responses Add your response