Ohm Walsh Micro Talls: who's actually heard 'em?

I've had my Ohm cylinders for a little over 4 months now and wanted to share my thoughts with folks that already have Ohm speakers and those who may be interested in purchasing Ohm speakers.
I use the Dirac room correction software that comes with my pre-amp (receiver).
In my opinion, the room correction does wonders for Ohm speakers. Depending on the geometry of the listening room and placement of the Ohms in respect to the surrounding walls, the Ohms can sound a bit boomy, the room correction really cleans up and tightens the bass. On the high frequencies, the Ohm speakers are also a bit soft. When I looked at the frequency response curve, there is a clear drop beyond 10Khz,  which I bumped up a little in Dirac. I have compared the equalized vs direct signal on multiple occasions and the difference is very noticeable. The bass gets much much cleaner and the high frequencies also get "brighter". Overall, I would not want to use them as studio monitors but the Ohms certainly have a lot of good attributes. The soundstage and imaging of these speakers are flat out amazing. you can listen to very broad range of music genres with these speakers and it does an admirable job. In my opinion, these speakers really shine when you listen to live music recordings. A little bit of bass management and bump in the higher frequencies go a long way to make these speakers an absolute blast. I would also like to mention that I am by no means a seasoned veteran in audio gear critique. In total, I have had 7 pairs of speakers and the Ohms would definitely be my favorites so far.   

rodm - innteresting. Your post made me realize that when I hooked my 2000s up to that Pioneer AVR, I was using the Pioneer’s MCACC, Pioneer’s fairly effective room correction software. I normally do not have the Pioneer in the 2-channel chain, so stereo music listening is done without room correction. Hmm. You know, until this month, my system has been pretty much the same since 2011. Looks like some changes may be coming, provided I can find the funds.

bondmanp, If you don't have an ideal room geometry and you can't have a wide gap between the speakers and the front walls, the room correction definitely helps in cleaning up the lower frequencies. Most audio gurus don't recommend room correction for higher frequencies but in my personal experience with the Ohms, the boost in the higher frequencies is a welcome change. 

rodm_2001 - Thanks.  I actually prefer a gradual roll-off of the high frequencies.  The 2000s do in fact fit that bill.  In fact, a recent cable upgrade has made the 2000s brighter, alsmost too bright.  A borderline situation.  I do have a decent amount of room behind the speakers, and a little less on the sides.  Also, my ceiling is only 6' tall.  And my low frequencies are surprisingly smooth and extended without any EQ, thanks to a pair of subs in the front corners that were designed(!) to go in the corners.  When I get my amplifier back, I will revisit all of this.

Nice used pair of microwalsh speakers in Joseph audio room at cap aud fest today. For $500. I’m tempted. Jos audio again one of the best sounding small rooms at the show.  Other show specials there as well including a nice pair of used Bel Canto ref500 amps.