Agree with griffithds and jmcgrogan2, check to make sure you're using the right input and switch out the tubes. I think that using the 12AX7 tubes as suggested above will help, as 50 db of gain from the 12AU7s might not be enough for your cartridge.
Newbee help- Volume low even at full preamp volume-???
Guys- my first turntable- Dr. Feickert Firebird- arm- TTW jelco- cart Charisma MC-2: Specs-
:Cartridge Weight: 12 gCartridge Body: aluminiumCantilever: sapphireStylus: super fine line contact nude diamondVertical Tracking Angle: 20 degreesCoil: pure iron crossed-coil with single crystal high purity copperOutput Voltage: 0.42 mV at 3.54 cm/sec. Internal Impedance: 14ohmsFrequency Response: 20 –25,000 Hz ± 1 dBChannel Balance: better than 0.5 dBChannel Separation: better than30 dBDynamic Compliance: 10 um/mNRecommended Loading: 100 –1,000 ohmsRecommended Tracking Force: 2.0 g ± 0.1 gTracking Ability at 315 Hz / 2 g: 80 uMRecommended Tonearm Mass: medium
Phono preamp- Rogers PA-1A
Preamp- Wyetech ruby-
Ok- I set the Rogers Phono Pre per Charisma rec.-"We would suggest you to try the 100 Ohm and 10K Ohm of the resistive selection. Capacitance is sensitive to moving magnet cartridges, but not moving coil."
I get very low volume even with the Wyetech preamp at full volume- Please help a Newbee out- What am I doing wrong??thanks gary
:Cartridge Weight: 12 gCartridge Body: aluminiumCantilever: sapphireStylus: super fine line contact nude diamondVertical Tracking Angle: 20 degreesCoil: pure iron crossed-coil with single crystal high purity copperOutput Voltage: 0.42 mV at 3.54 cm/sec. Internal Impedance: 14ohmsFrequency Response: 20 –25,000 Hz ± 1 dBChannel Balance: better than 0.5 dBChannel Separation: better than30 dBDynamic Compliance: 10 um/mNRecommended Loading: 100 –1,000 ohmsRecommended Tracking Force: 2.0 g ± 0.1 gTracking Ability at 315 Hz / 2 g: 80 uMRecommended Tonearm Mass: medium
Phono preamp- Rogers PA-1A
Preamp- Wyetech ruby-
Ok- I set the Rogers Phono Pre per Charisma rec.-"We would suggest you to try the 100 Ohm and 10K Ohm of the resistive selection. Capacitance is sensitive to moving magnet cartridges, but not moving coil."
I get very low volume even with the Wyetech preamp at full volume- Please help a Newbee out- What am I doing wrong??thanks gary