Need input on new speakers


Hi all, I currently have a pair of Vandersteen 1 ci+ and a Lyngdorf TDAI 1120 and I love it, but it does not shine when I listen to Rock mostly Grunge. So I'm putting a smaller room together it is about 12x12. I will be using a Rotel 1572mkii. I am in the U.S. and want to stay around $2000. I am disabled and permanently in a wheelchair so in the room I sit about 7.5 feet from where the speakers would sit. New or used does not matter, floor standing or bookshelf. Thanks in advance for any suggestions.

gordo1962

Showing 2 responses by immatthewj

Also, the OP is not using a low-powered tube amp and the Rotel he’s planning on using puts out 120Wpc into 8 Ohms and 200 Wpc into 4 Ohms, which is more than enough power for these speakers. 

Understood, @soix , just wondering about the statement the Stereophile reviewer made was all.  

@soix , I actually found those speakers on ebay before you provided the link, and I also found the review on Stereophile.  I find this excerpt from the review interesting:

"With its 86dB sensitivity and 8 ohm impedance, the RM22si presented a consistently friendly load to the three different levels of tube power output I employed over several months."

(and the author goes on to describe the amps he used, the lowest power being from the Mesa Tigris--anywhere from 20wpc to 35wpc depending upon which triode or pendode setting he used.)

What I found interesting (bearing in mind that I make no claims to have a real good handle on this stuff) is that a sensitivity of 86 does not seem like a real easy or "friendly" load for a low powered amp to drive.  And I am basing that mainly upon the discussions I have followed on this site.  (This was what I also questioned about the Totem Arros, a similar looking two way speaker in its own integral cabinet instead of stand mounted, with a sensitivity of 87 but nominal impedance listed at 4 ohms, and 20 wpc to 80 wpc being recommended power requirements.)  

I assume that what makes the Joseph Audios "friendly" is that the specs state that the 8 ohm nominal impedance does not drop below 7 ohms?