2. misc-audio
  3. 1158699111

Need help with room

I currently obtained a SPL meter and Rives test CD to try and diagnose why my system is fatiguing in the highs and lacks in the mid bass. When I performed the frequency analysis I noticed that I have a rather steep decline in decibels below 400 hz bottoming out at 125 hz and then rising a little to 100 hz then back down. On the other end I have a sharp decline above 6300 hz. The total swing in db from top to bottom is as much as 30 db btw. 50hz and 16k hz. I would like to smooth out the frequency response and have tried moving the speakers, but it mainly just moved the lowest point a few hz without really affecting the response more than a few db and I need a lot more. I also tried different interconnects with minimal success. I tried removing my home made acoustic panels that did change things, but not to the effect needed and panels will not compensate for my base suck out if that is what I have. I am curious about my source because it does seem to lack in the lower end when compared to other sources, but I would be supposed if they could be that different. If anyone has any ideas I would greatly appreciate it.
Thanks, David

Room is 10' x 11' with 8' ceilings. Speakers are set out on golden ratio from front and sidewalls. One large window with metal blinds and thin curtain on front wall.
Parasound A23/P3
Denon 3800 (source)
Audioquest cheetah and jaguar interconnects
Alpha core Python MI2 speaker cables
dhel

Showing 4 responses by dhel

dhel OP
40 posts
 
Thanks, I forgot to put that in. The speakers are Boston Acoustic VRM 80's. http://www.bostonacoustics.com/home_product.aspx?product_id=189
Recommended Amplifier Power
50-250 watts

Nominal Impedance
8 ohms

Frequency Response (3dB)
42Hz-20kHz

Bass Unit
Dual 5¼ (135mm) DCD copolymer

Crossover Frequency
2,500Hz

Sensitivity (1 watt (2.83v) at 1m)
90dB

Tweeter
1" (25mm) black anodized aluminum dome with AMD™

Weight
58 lbs (26.0kg)
dhel OP
40 posts
 
The test tones are single frequency tones. While trying to figure out what was happening I looked at the Rives audio instructions and realized that I have the SPL meter on an 'a' weighted and it is supposed to be 'c' weighted. This made a huge difference as the differences in that the frequencies are only 13 db difference from the highest peak to lowest trough across 40 - 12.5k hz. I now show a small bass boost as I thought should be in my room. I am able to correct this. Now can I make the highs a little less fatiguing? I will try some absorptive panes at the first reflection points and behind my head instead of the combo diffusion/absorptive ones I made.
Thanks Shadorne, your response indirectly sent me to the info I needed and the RealTraps web page is also helpful.
dhel OP
40 posts
 
Bad quick math the difference is now 23 db in audible range. I see my bass node now and I can correct that, but I have a narrow +10 db spike at 630 hz that I am not sure how to mitigate. Any ideas? Also, are absorptive panels at the first reflection point likely to smooth out the frequency response above 200 hz?
dhel OP
40 posts
 
Thank you for your response, I may consider going back to all copper interconnects to help tame some of the high frequencies as they can be fatiguing. The question around smoothing out the response is mostly a curiosity; I am not too worried about it, but I would like to hear what audible difference a flatter feq. response would have. You also mentioned an interconnect, but I cannot identify or find info on it, dcaa?
Thanks
More to discover