My JL Audio sub is dead. What exactly happened?


So at my wife's request, I hooked up a Roku to my main system. Roku is a device for internet streaming movies and tv. The connection between the Roku and my preamp, a Meridian G68, was a 12 foot optical cable.

The first night, I hook up the Roku and it works perfectly.

The next night, I move some cables around, then I hook up the Roku again, exactly the same way as the previous evening. I get picture but no sound. Weird. I pondering what I might have done wrong when out of the speakers... POP. POP! POP!!!

Uh oh.

I dive for the amps, switch them off. The POPs stop immediately. But...

Now there's a TERRIFYING HIGH PITCHED PULSATING NOISE coming from somewhere in the room. I finally realize it's coming from the sub, a JL Audio Fathom 113. I dart across the room, switch it off.

I stand frozen, savoring the final moments of the fantasy that maybe things aren't that bad.

Here are some questions in no particular order...

1. I suspect the amp in the sub is fried. Does that sound right?

2. Where did those POPs come from? Could a damaged optical cable do it? Or maybe the optical cable wasn't fully seated?

3. Do I really have to ship this 150 pound sub to Florida? Or do you think there's any chance of finding someone local to fix it? (I'm in L.A.) The sub is out of warranty, btw.

4. I tried to take the panel off the rear of the amp (I know, lethal voltages inside) with the thought that maybe I would just bring the amp portion of the sub to someone local to fix. I removed about 12 screws from the rear panel and still it doesn't budge. Why can't I open this thing?

If you have any suggestions, I'm all ears. If not, thanks for reading.

Bryon

P.S. The rest of the system appears to be fine.
bryoncunningham
My F113 blew and was fixed on warranty.  Same thing happened (loud horrible noise when plugged in but switched off), now off warranty.  Suspect its due to those cheap caps having blown.  jlithen, did you post your photos of the fix anywhere?
Hi Guys,

I have a F112 that I bought used i 2012, last week it stopped working(completely dead, no lights or sound).

I suspect the same issue here, with blown caps. I have managed to get the amplifier out, but are unable to locate which caps that needs replacing or where to start to look, as there a no visible damage.

Any advice? I plan to try to resoldier the defective caps
 
http://www.audioholics.com/subwoofer-reviews/jl-audio-fathom-f112-subwoofer-review/intfeat.jpg/image...
Ok, so I dissembled the amplifier(loosened all the wood screws on the back of the subwoofer) and pulled the amplifier off.

It was 1 defective cap that needed to be replaced on my sub. I picked a new cap with slighty higher temp. rating. The value of the one I used is 35Volt 100μF, and 105°C

See attached picture, I highlighted the cap that needs replacement in the red circle in the upper left corner: https://imgur.com/a/J3LAn

According to repair workshop this is usually the cap that breaks, but It might be the one on the right side aswell.

Thanks for reporting back. It's a shame when there are no answers in these threads, just questions. 

Did you get to replace the cap yet?