Musical Fidelity A3.2 dual mono integrated amp repair

I found this on the Musical Fidelity Support page (also see link below):

USA Focal Naim Customer Support:

Email: ticket@focal-naim.com

Phone: 1 800 663 9352 Ext. #9

Musical Fidelity Support Page

I suggest you call the above 800 number and ask.

Did you check the fuses?

Thanks, I'll follow up on both responses, appreciate it.

Check the speaker fuses also. A little tuner spray/lubricator will cure your volume static. 

A3.2 pic:

DeKay

Thanks again for the responses and sorry for the delay: I contacted Naim and they recommended contacting Technetron in New York City. Took a little while to get the parts, but the repair was super--full cleaning, new caps and pots, replaced the volume control. I'm happy to have the amp back.

One question: they asked if I ever powered the amp down, I told them no (except for two major power outages it's been powered on for the 15 or so years I've owned it). They said that I should power it off when not using it since it runs pretty hot and constant high heat will damage the internal components over time.

Is this recommended advice for solid state amps?

Thanks again.

foxree13

Good to read that Technetron came through on the repair. If the A3.2 does not have a "standby" mode. Then, yes, power it down because of generated heat.

Happy Listening!

Great, thanks for the advice!!