Modifying Philharmonic 3 crossovers

Use Mills. Use same value CMR caps (although Reliable Capacitor Theta are my personal favorites). Don’t bypass.

Hi, thanks guys for your responses. I'm seeing varying opinions regarding bypassing. Are there down sides to bypassing?

So I just soldered all the Clarity CMRs and CSA capacitor and the Phil 3 speaker sounds fantastic! The speakers sound a lot more 3 dimensional and much more atmospheric and organic. Thank you everyone for the advice and especially to Eric! This would have been much more difficult without you guys' help. I did receive the mills non-inductive resistors and plan on replacing the ones in the speaker this weekend. I hope you guys have a bit more patience but I wanted to know more about inductors. Do they make a big difference like the capacitors? Do you guys have a certain brand that you guys would recommend? From the way that the inductors in my speaker look like, I believe I have ERSE inductors. Are the a good brand?

When I upgrade speaker crossover inductors, I like to change iron core inductor to air core. Air core inductor will be much bigger than iron core in order to keep the DCR as close as possible.

Thanks for the advice, I do actually have a few iron core inductors, so I may change them out and see what happens.