2. analog
  3. 1243551141

MintLP arc protractor

I'm talking to Yip about a protractor for a Rega RB-300 mounted on a VPI HW-19 Mark III. To verify the desired 222mm spindle to pivot distance I cut a piece of cardboard 222mm in length. I measured from the spindle to the center of the armboard mounting hole. It looks to be spot on at 222mm. Is there a more accurate way to measure so that I can confirm my initial findings?

Wendell
narrod

Showing 1 response by peterayer

peterayer
1,382 posts
 
Doak,
I found that I was close to being on the arc of the Mint with my SME protractor but cartridge zenith (rotation) was way off. Dan ed is correct to suggest to also check cantilever alignment at the null points using the Mint.
More to discover