2. analog
  3. 124092-19004

Michell Gyro SE + SME IV upgrade path

I'm spending more and more of my time listening to LPs and thinking of upgrading my turntable.  The system is really starting to jell, but I have neglected the upstream portion of the system as I have focused on improving the downstream portions (amps, cabling, speakers) as well as dedicated power.  

I would like your thoughts on which of the three following paths is the wisest (long-term) course:

1) Upgrade Michell Gyro SE by adding a HR power supply (allowing speed fine tuning and electrical isolation), possibly adding Orbe spider base and platter, rewiring the SME IV (eliminating both the cartridge and SME DIN connections), and adding wall shelf as per the suggestions of the forum;

2) Trading in the Michell Gyro SE and SME for VPI Classic Signature or other non-sprung turntable in the less than $10k range (including arm); or

3) Selling the Michell Gyro and keeping the SME IV (possibly rewired) and replacing it with an SME 10 or 15A.

I'm open to other suggestions.  These are down the road upgrades so listening and comparing are options as the upcoming AXPONA event or at Chicago many hi-fi dealers.

The objective is to get as good as sound as I can from my improving system.  The analogue portion of my system and path is as follows:

1) Michell Gyro SE + SME IV (with VTA adjustment and damping) + Shelter 90X
2) Silver Breeze DIN to RCA
3) Pass Labs X-Ono
4) Audience AU24SE XLR
5) Pass Labs X-1
6) Audience AU24SE XLR
7) Pass Labs XA100.8
8) Audience AU24SE Speaker
9) Magnepan 3.7i plus two DWMs

Audio rack needs to be upgraded as the Salamander Synergy rack could be a more solid foundation.  (Dedicated room and power circuits with hi-fi outlets, Audience PowerChords SE and power conditioner)

Thanks in advance for your thoughts and comments,

Tom
tgonzales

Showing 2 responses by folkfreak

folkfreak's avatar
folkfreak
1,349 posts
 
Exactly -- the Gyro needs an arm that has the same "swing" -- which is not the SMEs strength. Adding the Orbe upgrades and the HR will help with the stability and blackness you are looking for but you will still be stuck with the coloration in the arm. 

One cheaper option to experiment with would be to purchase a Wand+ unipivot -- at $1K it's a real bargain and you can see if you like the sound going in that direction.

I actually sold my SME (at this time my number 2 arm on my dual arm EAR Discmaster) and replaced it with a Wand+ for my Miyajima Zero -- no comparison the Wand is much more musical and involving. 
folkfreak's avatar
folkfreak
1,349 posts
 
Congrats on your nice system and happy to chime in with my suggestions on ways forward. As a prior owner of both the Gyro and the SME IV I’ve been in exactly your position. I actually changed my Gyro for a first generation Orbe and then added the HR supply and a wall shelf (GrandPrix Audio Brooklands) both of which really helped so I imagine the Gyro upgrades you have in line will all be positive

However where I would focus most attention if I was in your shoes would be In swapping out the arm. The IV has a very dry and even rough sound and it was only when I changed mine (first to a Triplanar VII and then to a Durand Kairos) that I realized how much it was coloring the sound. I’d sell yours and explore alternatives, personally my taste now runs to unipivots such as the Kairos but Moerch arms are another classic combination with Michell turntables

With an upgraded table and a better arm you can then explore cartridges - anyway hope this helps and let us know if you have any more questions
More to discover