McIntosh Guy Going Tubes? (Maybe?)


Need some thoughts, comments, advice: present system (mainly McIntosh): Wilson Sabrina’s, MC601 monos, C52 pre, MEN220 room cor, MB50 streamer, MCD80 spinner, PSAudio P10 regenerator. My thoughts are to go analog/tubes via MC275 MKVI monos with C2600 pre(and undefined TT). Pros - Cons?
bradlye

Showing 2 responses by bthartman

I've never had McIntosh gear, but I also have the Wilson Sabrinas and thought I'd put in my experience.

Currently, I'm driving them with an ARC Ref6 preamp and D'Agostino Master Classic stereo amp.  This combination sounds fantastic and very musical.

HOWEVER: I recently got a Cary CAD300SEI integrated amp for my office setup (SET 300B tube based and 15 Watts per channel).

Had some of my friends over to hear it, so I brought the Cary and the Omega single driver speakers from my office to my main setup.  On a lark, plugged in the Sabrinas and was amazed how well this amp handled the Sabrinas' difficult load (87 db sensitivity, 4 Ohm nominal load with a dip to 2.53 Ohms).  Besides being able to drive them to a satisfying volume level, the midrange just came alive.  Bass was not quite as controlled as with the D'Agostino, but still quite satisfying.  The Cary is in for some upgrades to the capacitors and recitifiers, as well as adding a left and right pre-out for my JL Fathom subwoofer, and my plan is to use the Cary and sell on the ARC and D'Agostino.

My point is that you shouldn't get too wrapped up in the watts a tube amp is rated for - I suspect my satisfaction with the Cary is more due to current delivery than the watts it produces - but that you should get in some different types of amps in for a home audition if you can and see what floats your boat with your Sabrinas.
@kalali - Actually, it was very surprising.  My room is fairly large (14' by 20' in the immediate area, and open to about 40' in the off axis in an open floor plan.  Listening position is about 12 feet from the speakers.  The room is fairly lively with hard wood floors, though tempered with an area rug in front of the speakers, plus cloth covered furniture and a couple of drapes next to the windows.  My listening ranged from both small and large jazz bands, as well as rock and symphonic works.  I was very concerned in my evaluation that all my very wide listening tastes were represented.

I truly was surprised at how well the SET amp handled everything.  As I said, bass was not quite as tight as with the solid state amp, but I only felt it was lacking in direct comparison.  I also played pretty loud (for me, anyway), registering an average of about 85 db at the listening position using an SPL meter.

I don't have a great deal of knowledge about electrical engineering, but after doing some searching with google it MAY be that judging speaker and amp match by looking at wattage might not be the whole story and that current delivery plays a significant role in matching.

Again, though, this is my experience, with my room and equipment, my taste in volume levels, and of course, my ears.  I'm just suggesting that the OP shouldn't write off a lower power tube amp, particularly with the Sabrinas, without direct evaluation.