While you have the panels out you might consider cleaning them in the shower, especially if they are older or have been exposed to smokers or in a common room near a kitchen (cooking smoke/grease). Restored the sound nicely on a secondhand set of Prodigys. I noticed a fine black silt coming off the panels when rinsed. Check out the Martin Logan owners site for a sticky note explaing the procedure. Highly recommended.
6 responses Add your response
tablejockey This is where the groove will be if it's the same system https://ibb.co/3hWRVTQ This is the Theos Cheers George |
tablejockey I don’t know about your model. But the three models I had which were bigger even bigger again and biggest, you pressed from behind the "back" center of the panel (this shortens the panel width) and with the other hand on the "front" edge of the panel push backwards "after the the edge is released from the a groove in the frame", and out it pops out backwards. (in other words it uses the panels expanded curve to locate in a grove of the frame) Like this ham fisted guy does it putting it in and then pulling it out https://youtu.be/rD-QJ4FoFTE?t=38 This is where the groove will be https://ibb.co/3hWRVTQ This is the Theos ****But you have to disconnect the 3 wire push on Molex connector at the bottom before doing this.**** Cheers George |