I have some scematics but they don't match the service-manual I found on vinyl engine.
The Cotter MKII have 5 pins horisonataly (1-5) and 4 pins vertically (A-D). Mine is wired like this:
A1+A2,A3+A4
B1+B2+B3,B4+B5
C2+C3,C4+C5
D1+D2,D3+D4+D5
+ meaning they are connected.
The wiring instruction I have says this is the type "P" or "I" (bad copy), made for 25-40 ohm.
There is an other option calltd "X" or(P-P) for source impedance <20ohm. Does anybody know how I should wire to match my XV-1s (6ohm). In the owners manual the X and P-P are two different models.
The problem is that the wiring instruction and the owners manual don't state the same impedances for the different types of the Cotter.
The Cotter MKII have 5 pins horisonataly (1-5) and 4 pins vertically (A-D). Mine is wired like this:
A1+A2,A3+A4
B1+B2+B3,B4+B5
C2+C3,C4+C5
D1+D2,D3+D4+D5
+ meaning they are connected.
The wiring instruction I have says this is the type "P" or "I" (bad copy), made for 25-40 ohm.
There is an other option calltd "X" or(P-P) for source impedance <20ohm. Does anybody know how I should wire to match my XV-1s (6ohm). In the owners manual the X and P-P are two different models.
The problem is that the wiring instruction and the owners manual don't state the same impedances for the different types of the Cotter.