Locating capacitors

You can most likely use any electrolytic capacitor of equal or higher voltage rating - Mouser have several make sure it fits size wise and of course make sure you get the right value (uF) - also it would not hurt to use a 105'C cap they hold up longer.

Good luck

Peter

Axials are especially hard to find current replacements for. Most all the new designs are radial (with the leads coming out of the same end). Axials the leads come out of opposing ends.

I think Vishay makes a line of current axial electrolytics (you can find them at DigiKey), but the range of values and voltage ratings is limited. You also did not mention the capacitance value.

I did a Digikey search for you for "axial electrolytic capacitors", and no parts come back at 350 V. Highest is 200 V, and all those are made by Vishay, with values from 10-100 mfd.

Parts Express has some high voltage axial electrolytics under the name "Ruby Gold". They are 350-500 V parts, from about 10 mfd up to 100 mfd:

http://www.parts-express.com/wizards/searchResults.cfm?FTR=ruby+gold+capacitor&search_type=main&WebPage_ID=3&searchFilter=ruby+gold+capacitor&x=20&y=10

Also, are you sure this is an electrolytic cap and not a film cap?

Post the capacitance!!!

Mouser capacitor

Heres one that should work

Happy Soldering :-)

Peter

Make sure the amp has been off and you know the high voltage power supplies have been bled. Otherwise you might be in for the shock of your life. I also suggest you get caps rated at 105C. The Panasonic's are quite good. The bigger issue for radials in lead spacing. Make sure you get that close or the cap will not sit flush up against the circuit board.

At that capacitance you might also be able to find a polypropylene film type. It will be a larger and more expensive, but sonically a vast improvement. And those will be radial so they may not fit as well.

Steakster:

I would choose the cap based on operating temp (105C preferred over 85 C), then the lowest ESR (equivalent series resistance), then finally ripple current (highest best). Load life is generaly the life of the capacitor operated at a given set of conditions specified by the manufacturer (like maximum temp of 105C and max ripple current) before it begins exceeding its specs (say for example, leakage current, which may steadily increase as the cap gets older). A 2000 Hr rating will not be as good as a 5000 hr rating, for example.

Parts Connexion. There sharp also, contact them and they can help you out.

It doesn't need to be a Nichicon. There are plenty of good quality cap manufacturers out there. Why don't you call the manufacturer of the tube amp you own and see how much they want for the part.

Digi-key parts, GTC electronics, Newark Electronics