KEF 103.2 - what to expect?


I was looking through my father's basement and discovered his old KEF 103.2 speakers gathering dust. From what I have read on the web, these are great speakers.

My current system uses an Arcam CD73 player, paired with an Exposure Super XV integrated amp, hooked up to a pair of Wharfedale Pacific Evo 8 speakers. I've spent a while developing that budget system and like it very much for listening to classic jazz.

I was thinking of using the KEFs on my "second system." I have a NAD 320BEE integrated amp laying around, along with an Exposure CD player (don't know the model, doesn't say) or a NAD 521 CD player.

3 questions:

(1) Is the NAD integrated amp powerful enough to run the KEFs? I noticed the KEFs are 8 ohm speakers, which I believe means they are harder to drive.

(2) One of the KEF speaker tweeter's looks slightly damaged. Not torn, but there is a fold/crease in the tweeter fabric. I haven't listened to them yet, but is there anything I should listen for to see if the tweeter is damaged?

(3) Anyone ever used an Exposure CD player (probably from the same time-era as the Exposure Super XV integrated amp I have)? I presume it is a step up from the entry level NAD 521 which served me well for many years.

Thanks,
David
dmloring

Showing 3 responses by stanwal

No, 8 ohms are the norm, it is 4 ohms and below that are hard to drive. The tweeter it probably all right. You can remove such things in several ways, using a vacuum cleaner VERY carefully, a bent pin, and gently pushing it with a finger. The current Exposure Classic CD player has a very good reputation and some of the older ones as well. Plug it in, turn it on at a low volume and see what it sounds like, I think the NAD would work fine, check the heat sinks when it has been on for a while to see if it is getting too hot. Do not use the "soft clipping" feature as it cuts the available power in half.
Yes but it is not common and it is usually headbangers who do it. What makes you think the 103.2 are demanding? Usually you run into problems with low impedance speakers. It all depends on using discretion, if you have a very large room and play loudly then you need a lot of power, but for jazz in a normal room you are not going to be drawing large amounts of power constantly. I can't give guarantees but I would try it. After 15 minutes feel the heat sinks, if they are very hot you have a problem, if not go ahead.
I would think that they are probably for Banana plugs. Go to the local Radio Shack and check. You can fasten them to the ends of your speaker wire, get the non solder ones,