2. cables
  3. 169349-162470

Jorma no.3 cut a small piece and make jumpers

Hi all, I have bought single Jorma no. 3 speaker cables and I want cut a small piece to make jumpers out of them for my bi-wired speakers. I want to use crimping spades. Is this even possible or will the wire inside be too minimal? and is it bad to cut the existing factory terminated plugs? Want to use Oyaide spades to reterminate, would you do this or keep everything original and look for a different solution? Thanks for your opinion..
faustaudio

Showing 1 response by celtic66

celtic66
1,741 posts
 
imhififan  Yes, you have it right.  I've done that with numerous speakers I've crossover component and wire upgraded internally.

noromance  I think you have it right also, I see no reason to not simply use the bare wire through the posts (if possible).  Done it numerous times to good affect.
More to discover