jolida 502b manual bias adjustment

I recently sold my 502p…a great amp that served me well for years. The 12AX7s are on the "inside" of the small tube pairs. I had a "Littlite" gooseneck light over the amp that I would hang the bias meter cables over to keep them under control when using the meter to check the bias, but burning my fingers was part of the ritual…however, the bias LEDs were very accurate and I didn't really need the meter.

http://www.jolida.com

Have you tried contacting JoLida in Maryland about a manual (also your tube placement question)?

However, from the image here, the 12AX7s are on the inside.
http://www.usaudiomart.com/details/649259448-fs-jolida-502-brc-integrated-tube-amp-w-upgraded-tubes/...

Can anyone tell me where to find a manual- also there are four small tubes - do the 12ax7 or the 12at7 go on the inside or the outside tube sockets?

Veroman

Do you have the 502B and if so is it modded. I have a 502A that was modded by Response audio and I love it. I can only imagine how much better the higher end tube amps sound.

did not mean to imply your method was inferior, etc... i was speaking to OP. just wanted to point out that the connections to spikes do not have to be rock solid to get job done. if i had longer tools it probably would be easier as a matter of fact but the probes can stay in place free standing long enuff to let go of them for adjusting slot screws. ntl, i think auto bias is a gret option, i wish that feature was offered on mine but it was introduced later on.

I'm not overly concerned. It's just an easier method that works for me. I don't have to hold on to probes with one hand while trying to make adjustments with the other hand. This way I can leave the amp where it is in my rack and make the adjustments. But hey if it works for you that's great, it doesn't for me that's why I chose this approach.

i use shorter probes and a short screwdriver and have never had a problem. i have big hands as well. i think you may be overly concerned with forcing probes into a real tight and locked position. the probe slots are not top of line but then again you do not need to sink the probes in very far to get a solid read out. i use a digital radio shack unit and it is 1,2,3.

This may be old news but, this is what I use on my Jolida 502A. It is a Bias Rite model #BR-4 by Weber. It shortens the bias time and allows you to make very accurate bias settings and compare each socket to make they are all the same at the turn of a switch. The test points on these amplifiers are not very good in my opinion. I love using the Bias Rite it has worked very well for me.

oh...ok - gotcha - I picked up an inexpensive multimeter from Sears. Probes are 4-5" long or so. It does take a little care to get a stable connection and when moving them, but again - no burns yet (famous last words).

the bias pots are not the problem it's where you put the probes to do the measuremants. one guy said use gloves or i guess find a meter with probes as long as chop sticks.

I own the JoLida 502B. It was my first introduction to tubes. It is manual bias. Just use a long handled screwdriver...haven't burned myself yet. A 5 minute job at most.