Hmmm, I did set it properly (at 1.5) but everytime I reset, and it pulls less, it eventually goes back.
Issue with the Arm on my Rega P1 Turntable
I bought a new Rega P1 recently. It has an adjustable weight on the back. I set it where the instructions advised, all the way up to the end of the threads nearest the top of the arm).
After playing it for a week or so, the arm started to pull a bit away from the center of the plate. So I readjusted the weight and it seemed to work better, just a little bit of pull. I played it a little more and now it's pulling again.
Is this just typical? Nothing to be concerned about? It certainly makes placing the needle on the vinyl a lot more difficult.
After playing it for a week or so, the arm started to pull a bit away from the center of the plate. So I readjusted the weight and it seemed to work better, just a little bit of pull. I played it a little more and now it's pulling again.
Is this just typical? Nothing to be concerned about? It certainly makes placing the needle on the vinyl a lot more difficult.