Is there such a thing as too much power?

Hi @bob0398 ,

Most of speakers (Tannoy, Klipsch,...) have overstate sensitivity specification. 
Even vintage speakers like my Altec 604E have 102dB/m by spec, but in real live just ~97-98dB.
On other hand a lot of tube amplifiers sound slow. It happens not because they have low power, but because a bad design. For example, a lot of 300B SET amplifiers use 6sn7 (or even less powerful) driver tube. The result is bloated bass and slow sound, bad transient .

Regards,
Alex.

You may be correct about the cause. 

The tube amps are described as: a pair of tube monoblocks using the 6B4G tube in push pull configuration. The 6B4G is a 2A3 with a different base. These amps put out around 16-18 watts. Built on Magnavox console chassis with the 50’s/60’s Magnavox transformers. The parts are industrial but quite good quality. These were built in the 90s or early 2000s and were formerly owned by Charley Kittleson of Vacuum Tube Valley. Tubes are 6SL7, 6SN7, pair 6B4G, pair 5R4 per amp. 

The other amps are Jeff Rowland 501 with separate power supplies.  The external ps make the amps sound exponentially better, to my ear, than without.

Alexberger:  I neglected to add that the speakers which recently replaced Magnepan 3.7s are Robert Bastanis Mandalla Atlas with the powered 18" woofers.  Some have said they test at 100 or 101dB efficiency.  I can't verify that though.

Stupid thread, the answer is NO.   Next!!

So what is it burns out speakers then? 
Don't quit your day job.