Why not just drive the Elipsa's with it until you get the proper setup?
Is the FMJ A32 intergrated phone stage any good?
I'm looking at conserving some money while in the process of setting myself up with a turntable.
It has been suggested that I could run a table through the FMJ phone stage and use its "tape out" to feed my pre-amp. This would allow me to focus funds on a better cartridge and then upgrade the phone stage at a later date when the right one appears.
If the A32 is going to do a decent job this sounds like a valid solution.
Arcam specs the MM stage as
Input sensitive 27mV
Input Impedance 47 k ohm
Signal to noise -79db
Overload margin 35db
Currently looking at Dynavector , Hana SL, etc for cartridge on a Well Tempered Amadeus
It has been suggested that I could run a table through the FMJ phone stage and use its "tape out" to feed my pre-amp. This would allow me to focus funds on a better cartridge and then upgrade the phone stage at a later date when the right one appears.
If the A32 is going to do a decent job this sounds like a valid solution.
Arcam specs the MM stage as
Input sensitive 27mV
Input Impedance 47 k ohm
Signal to noise -79db
Overload margin 35db
Currently looking at Dynavector , Hana SL, etc for cartridge on a Well Tempered Amadeus
3 responses Add your response