Is my anti-skating too strong.


I’m trying to adjust the alignment of the Ortofon Black Quintet cartridge on my Music Hall mmf 9.3 turntable.  When I put the stylus down on the alignment protractor, the tone arm pulls to the outer edge of the turntable.   Should I disable anti skating when doing alignment or is it set too strong?  Obviously haven’t done this too often.
Also, when listening to the anti skating track on The Ultimate Analogue Test LP, there is noticeable distortion at the end of the track which indicates too much or too little anti skating.  Any guidance here?
udog

Showing 1 response by clearthink


mijostyn
"friction is much lower in the record groove than it is on a blank record. This is counter intuitive but lets see if I can explain it so it makes sense. The major determinant of friction in a record groove is VTF. Next is the surface area contact."

This is not at all accurate, correct, or true you have a profound, distinct, extreme lack of knowledge and understanding of very basic, elementary, introductory physics.