Integrated Amps - Ayre vs Pass Labs


Hey all,

In the very preliminary stages of starting a two-channel system from the ground up. I’d like to go with an integrated to save on space.  No phono stage necessary at this point. I’m open to an incorporated DAC but it’s not a must have. Speakers, sources, etc. TBD.

Has anyone had experience hearing Pass’ INT-250 against Ayre’s AX-5 Twenty?

Thanks for reading,

CJ
blokemate700
I am a very happy owner of the Ayre. It replaced significantly more expensive separates (Modwwright KWA-150SE w/Cary SLP-05 w/ult. upgrade) and yet I greatly prefer its sq. Dead quiet with full rich sound. I am sure the Pass is great as well, although I have always found Pass to be slightly noisey and too hot. I would not buy w/o listening to both.
Both are excellent.  What speakers are you driving?  The Pass is a beast if you have a difficult load to drive.
Bobheinatz...Speaker selection far from set in stone.  I've been a MartinLogan fan for years but will certainly consider a dynamic loudspeaker as well.
You should also consider the Gryphon Diablo 300 if you have the budget.Optional DAC available.
@blokemate700 - imho - you need to lock down on your speaker selection first - then look for the right amp. Many parameters like sensitivity, listening level, impedance to frequency response will play a critical role in amp selection. Some speakers have bright top end which may need a tubey or drak amp to tame it. again - this is my 2c - ymmv. btw - i have the pass x250.5 and i believe the power section of the int-250 is almost identical to the x250.5. I love the pass house sound - doesnt sound anything like a solid state. good luck!