With all due respect to previous posters, I would not mess around with a power cord. I suggest the best TT power supply that you can afford. Comes with a cord. Nottingham's Wave Mechanic is very good, Walker is said to be good (for AC synchronous motors). For DC motors, perhaps Origin Live or ???.
It's good to isolate the phono stage from the TT motor, unless you get a regenerating TT power supply. One way is to drive the motor from the other leg of the 220VAC. Recall that power from the pole is 220VAC. That is split at your breaker box into 2 x 110VAC - two legs. Get an adjacent pair, use one for phono, one for motor.
Alternatively, you can use power supply filters and isolation transformers,
I built my own controller after buying a Wave Mechanic. It's based on a precision telescope controller out of Art of Electronics. Improvement was significant - should have been, considering the parts cost more than the assembled WM. (air bearing TT, ESL's).
It's good to isolate the phono stage from the TT motor, unless you get a regenerating TT power supply. One way is to drive the motor from the other leg of the 220VAC. Recall that power from the pole is 220VAC. That is split at your breaker box into 2 x 110VAC - two legs. Get an adjacent pair, use one for phono, one for motor.
Alternatively, you can use power supply filters and isolation transformers,
I built my own controller after buying a Wave Mechanic. It's based on a precision telescope controller out of Art of Electronics. Improvement was significant - should have been, considering the parts cost more than the assembled WM. (air bearing TT, ESL's).