Impedance????

I am biamping 2 nad2200 amps to a set of Paradigm monitor 11's V.3.

I want to make sure I am at 8 ohm coming to the speaker.

ok, I have the amp set to 8 ohm and the speakers are rated at 8 ohm, but does the fact that I have the Amp/speaker set up vertical(v/s active) biamping change the impedence v/s 1 amp run to both speakers?

Yes, that is correct jim, that is what I am asking.

DLEWALLEN

ok, I have not received the pre-amp i purchased yet(should be here next week) but it is a NAD 1600, I do not know if it has enough out-puts for bi-amping, if I use a "Y" I am changing impedance, So what do I do to biamp?

Thanks so much for the advice and help Seandtaylor99 , sounds like you have some experience in this. I will post back after the holidays when all is hooked up and let you guys know how it does.

Thanks again

David