I think I am going to attempt to make turntatbles


First off let me say I am not new to the audio realm. I am a computer engineer and yes I realize that deals in ones and zeros. However, I have made a few custom guitars. I know a master woodworker and a talented machinist. I have been searching for that perfect table for years whilst living in mediocrity. Well, I have the resources; why not make one from scratch. More than likely I am going to attempt a belt drive unit at first using an off the shelf arm... More than likely an SME. I am working on the power supply circuitry right now as my piece. Any one have any tips... I am thinking solid, large mdf plinth with an attached copper mat and either a heavy plinth with an acoustically decoupled motor or completely detached. Thoughts?
bc5k

Showing 1 response by br3098

Bc5k,

Good for you! I wish you the best of luck, and I hope that you have a little fun in the process.

My $.02 worth: designing a shielded MagLev bearing is not for the faint of heart, pocketbook or math skills. If you are seriously looking for an alternative to M2M or jewel bearings I would suggest that you look at air bearings. They are readily available in a variety of configurations and sizes, and are (relatively) low cost from eBay and other sources.