The Elekit TU 8600 amplifier
already comes with a volume pot built-in, what you need is change it to a higher quality same value pot, use a line level sources selector as preamp.
https://www.goldpt.com/sw4.html
https://www.goldpt.com/sw4.html
I need some techy help in order a preamp--resistor values.
Thank you in advance!
I'm thinking of ordering a Khozmo preamplifier until I can afford something much better. I'll be mating it with an Elekit TU 8600 amplifier.
The Khozmo website gives options on resistors. See https://khozmo.com/stereo_selector.html#remote
The Elekit has the following specs:
I'm thinking of ordering a Khozmo preamplifier until I can afford something much better. I'll be mating it with an Elekit TU 8600 amplifier.
The Khozmo website gives options on resistors. See https://khozmo.com/stereo_selector.html#remote
The Elekit has the following specs:
- Tubes: 300B x 2, 12AX7x1, 12AU7x2
- Rated output: 9.2W + 9.2W (10% THD)
- Rated input: 320mV
- Residual noise: 36uV (IHF-A)
- Frequency response: 7Hz-40kHz (-3dB)
- Input impedance: 50kΩ
- Output impedance: 4-6.3Ω, 8-16Ω selectable