I had this with an Audible Illusions modulus 3a pre. The tech fellow I hired could find no explanation. I used a DAC direct to power amp for about 3 Mos. One day I tried the preamp and the hum was gone. My neighbor was big into ham radio. He had moved. So rf?
Hum problem
Been chasing a hum in my VAC Ren 30/30 for quite a while. My technician has been all through it and does not find a problem. Says he cannot hear it in his system, but it's quite apparent on my Horning speakers (94 dB maybe?). As soon as the soft start relay starts to open, it begins to be audible and when it clicks open it's fully audible, maybe from 5-6' away, with the pre-amp fully attenuated. Once you advance the attenuator past about 9 or 10 o'clock, it starts to get louder, but not before.
It's not a transformer mechanical hum; no sound at the amp but clearly audible through the mid range of the speakers.
Present w no other components turned on (or any/all turned on). No change after swapping out power cords, lifting ground, swapping interconnects. Changing the position of the ground switch on the amp has no impact. Same w AC straight from the wall or w AC from a Dodd Audio Balanced Power System iso transformer. Since this is a transformer/tube amp (not an OTL), I assume there can be no DC offset, and cannot really check that because I don't think I can operate it w/o a speaker load and the info I find on the web says it must be checked w/o a load.
Any ideas before I ship this 85 lb beast back to VAC?
Any ideas before I ship this 85 lb beast back to VAC?