2. speakers
  3. 186879-184623

How to make the Focal Kanta No. 2 speakers sing?

Hi!

My first post here and I would like to hear your thoughts and tips for "warming up" my Focal Kanta 2 speakers.

 

TLDR

The sound from my Focal Kanta 2 speakers in my room is a bit shouty, bright and thin sounding, clearly lacking level and emotion in the lower mid range. Bass is good, quick and quite deep though.

Any tips for getting more "vocal warmth" into the system? Tube preamp, Dirac, ...? I see that many use old school power hungry amps that can heat your house during winter to drive Focal speakers. Is that really needed or can I get away with a modern amp that doesn’t cost a fortune.

 

More in depth information

In my living room (5.3 x 4.1 x 2.4m) I have a setup with both 2 channel and a multi channel setup. They share the same front speakers and front speaker amp.

2 channel setup:

 

5.2 channel setup:

 

I focus mainly on the two channel setup here. Multichannel is used quite much also for streaming movies, but is ok.

So the main issue for me is that the sound in in the two channel setup is thin sounding with mids clearly lacking in the lower end. It can be fatiguing to listen for a few hours. Bass though is enjoyable, fast and fairly deep.

Earlier I had the Focal Aria 936 speakers as front speakers in the same room (connected to the Yamaha AVR at that time). I liked them but wanted to upgrade to the next level after a few years 😄 The Arias were more forgiving than the Kantas, had more enjoyable warmth in the mids and were a bit rolled off in the top compared to the Kantas. Not fatiguing at all. But everything else the Kantas do better.

I have also had some other speakers, up to half Kanta price range, in the same room where all have had fuller mids and a more forgiving sound: Dynaudio, Totem and Triangle floor standers as well as Buchardt and my really old B&W 602s3 (super full mids but super rolled off in the top) stand speakers. The Kantas are different animals to all these and seem to require the a more delicate and correct chain of components to perform.

I have messed around with speaker positioning quite a lot. It’s mainly the bass region that is affected. Mids not very much.

Options I’m considering:

  • Upgrading the Yamaha AVR to a Marantz Cinema 50 for example to get Dirac room tuning, and run the 2 channel system through this also. The quality of the Marantz might not be the best here to use as a 2 channel pre amp/processor.
  • Use a dedicated pre amp for the 2 channel system. Budget up to 2000€. Not sure what to look for? Used equipment is fine.
  • Tubes? Never really listened to tubes but from what I understand you generally get a more warm sound from them. Tube preamp? Not very modern but might do the trick. Schiit Freya + seems to be within the budget range for example.
  • Other 2 channel amplifier. As mentioned I have tried to avoid the nuclear power plants of amps. I see people recommending amps from manufacturers like Musical Fidelity, Sim Audio, McIntosh, Accuphase etc. But these are really costly and I feel they generally belong in an older age that we are moving away from. But it might be what is needed, I don’t know, haven’t really heard them play.
  • Treat the room more. I have a big sofa, a really big carpet and a few acoustic panels in the room (no real science behind them now). The room in itself is a bit "bright" so here I can make a better effort of course, regardless of other taken measures.
  • Get other speakers. I can also just face it that the Kantas are what they are, sounding thin in the midrange and lacking emotion in voices. Getting other speakers might be the easiest upgrade. But it’s not that easy to find and test speakers in your room either...

 

Long story. Any recommendations?

Thanks!

donald_dac

Showing 1 response by mijostyn

mijostyn's avatar
mijostyn
8,234 posts
 

Hi Donald,

Very common problem. You have two choices, acoustic treatment of the room or a room control preamp like the Thrinnv Amethyst or DEQX Pre 4. Ideally you would do both. First you need absorption panels at the major first reflection points. You find them with a mirror since sound and light bounce the same way. Sit in your listening position and have a helper hold a mirror at your eye level. Have them move the mirror across the front wall from behind the left speaker to the right. When you see the speaker in the mirror put a masking tape marker on the wall behind the mirror. Now continue moving towards the right and when you see the right channel speaker in the mirror mark the wall there. Now do the same maneuver on both side walls. These are the four main first reflection points and you need to put sound absorption panels at these locations. There are also first reflection points on the floor and ceiling which may need to be treated. This will get rid of some or even all of that "shoutiness" which we call sibilance, the bane of residential HiFi systems. If this does not calm it a room control preamp will. They will also give you a programmable subwoofer crossover should you ever feel the need for more slam. 

 

 

More to discover