High level MC or step up?


I will soon be in possession of a ARC SP-16 with a build-in phono stage (min 1 mV), and I have just discover that my current cartridge is a low level MC (0.2mV) that SP-16 would most likely not be able to drive. Should I go with a new high-level MC or a step-up transformer?
digmusic
No Dig, I'm using the BB in a Pro-ject RM10's stock carbon fiber arm. It's a very compliant cartridge. The Ittok and BB are both in pretty wide use. I'll bet that if you post a separate thread that you'll get a specific answer.

Dave
Dave,
Blackbird is acutally on my list of consideration. I will be putting it on a Linn Ittok, any experience with that combination?
I've always gone the medium to high output MC route with great success. Right now I'm using a Sumiko Blackbird. It's a great match for either my Bryston 1B's phono stage or my Pro-ject Tube Head phono pre-amp.

I love my Tube Head, yet I've read reviews complaining about tube noise when used with low output cartridges. With 2.5mV of output from the Blackbird, noise is not an issue, at all.

Dave
If you check recent issue of S'phile, there is a review of several SUTs and it talks about some of the issues associated with matching. IIRC, the bottom line is that matching is critical for a cart and SUT. And many LO carts are very sensitive to proper loading, so if you use an SUT, you want to make sure it is easy to swap out resistors.
IMO you are going about this backwards.The arm/cartridge combo is the most important aspect of an analog setup.Find the cartridge (that you can afford) that works best with your arm and proceed acordingly.
K&K Audio makes a very nice SUT. I believe it is $325 assembled. It can be configured for different gain levels and has the ability to allow you to swap resistors for proper cartridge loading without soldering. I used to own one and used it with a Hagerman Trumpet before I bought the K&K Audio SE phono stage.
I would skip both and buy the Soundsmith Strain Gauge system. It does away with the RIAA compensation and need for step-ups. It blows the doors off any moving coil cartridge I have heard, which include the best. I have the first production unit and have been listening in disbelief for the past 5 weeks.
OK, so far the consensus is to stay away from high-level MC. Care to elaborate a bit more for the inquiring (and not-so-technical) mind? I was under the impression the SUP requires greater knowledge in matching the electronic characteristics of the cartridge and the SUT? Would a Graham Amp 3 be a competent unit -- it definitely falls within my budget. Thanks
I'd go with a step up tranny - get a quality one, like the AudioNote AN-S2. Used ones have turned up here on A'gon from time to time.
My vote is for a good SUT. Stay away from cheap ones else you'd be better with a good active stage.
Post removed