@audiojan Thank you so much for that! I do what I can to route the cables that way. It’s quite a mess back there without a lot of room to spread things out like they should be. I am cognizant of it, though. I will also do as you suggest and disconnect the interconnect to the amp. I agree that isolating the amp from the rest of the system may provide some answers or direction.
Help with hiss
Hello Friends,
My speakers have developed an audible hiss that I am trying to chase down. The hiss can be heard from across the room and while music is being played. Sometimes, the hiss is pulsating and sometimes constant. It occurs at all hours, perhaps less so in the early morning. Sometimes there is no hiss at all and everything is silent. It is an intermittent issue that is unpredictable.
My speakers are powered by mono block amplifiers. Both speakers exhibit the exact same behavior. The monos are plugged directly into the wall outlet. I also plugged them into a PS Audio AV Power Center with no relief. I changed power cords with no relief. No other piece of gear is on, although all are plugged in and some are in standby. I turned one mono off of course stopping the hiss in that speaker. The other continued to hiss. In reverse, same result.
This is not a “hum” (like from a ground loop). It is the same hiss that you can hear with your ear next to the tweeter but much louder.
I’m happy to answer any questions at all to help me resolve this. Thank you in advance.
- ...
- 51 posts total
@forestg Wrote:
Just a thought, the Loki does have a wall wart style power supply. The two most common reasons for hiss is either a grounding issue or a gain staging issue. I know this may sound silly but my guess is check the amplifier bias, maybe it's drifting, causing the hiss. Wish I could be of more help. See Odyssey Audio below: Mike https://odysseyaudio.com/kismet-reference-amplifiers/
|
@ditusa Hi Mike, The Loki does have a wall wart. I’ll unplug it to see if that helps. I have several components that use wall wart style power supplies. I’ll check them all while I’m at it. I had thought of the bias issue. I’ve read several discussions, especially pertaining to Odyssey, about adjusting bias to change the sound. The only thing perplexing about the bias drifting is that both amps exhibit the identical behavior at the identical time. Can drift in one effect the other so directly? I understand that bias exists and that it is a “thing”, but that is the extent of my knowledge. It is not anything I would attempt myself. You’ve been very helpful. Thank you so much. |
This is a natural phenomenon. You can spend the rest of your life trying to figure this out. Based on the writings of Stereophile and others, this hiss is originating from your components. The noise floor is poor and this hiss is symptomatic of poorly measuring components. if your amp has gain adjustments try lowering the gain. Stereophile has written about this before.
good luck.
|
- 51 posts total