help with Gallo Sub-Amp

Hi everyone

Hello,

I am not familiar with the Lex, but I am with the Gallo.

I just had a look at the Lex users manual. I think that none of the main audio outputs will work. Except for the "AUX" all are filtered. Those except the subwoofer filter out the lows while the subwoofer out has a low-pass filter. Problem is the Gallo has its own log-pass filter, so you end up using 2 low-pass filters which does not appear to be a good idea. The Lex's low-pass filters will preempt the Gallo's low-pass filter controls.

With respect to the "Aux", I am not sure what "reserved for future expansion" means.

The audio out of Zone 2 seem not to be filtered. If you can get Zone 2 to see the same source as the "Main Audio Outputs", these should work. Use the "var" outputs there.

Hope this helps.
Jim Bailey

Thanks but the resistor can not be used because i will be using the sub amp for the second set of binding posts. The resistor is for those not using a sub amp.

http://www.10audio.com/gallo_ref3-1.htm

go to this link on how to dial better bass with your 3.1's
using a simple resistor across the sub posts..