Does the new sub have an adjustable crossover level feature? If so, you should set the level of the crossover fairly low (25Hz), which would then (I think) use the sub's crossover to send only signals >25 Hz to the main speakers. There are more technical sub experts on this board so you should get a much better answer than I can provide. Good luck
Help ... Totally stuck (subwoofer topic)
Hi, folks. Hoping you can help me here. Earlier this year I got a JL Audio e110 sub for my two channel system. Using a pre/power combo - no receiver. Set up is B&W N804 speakers, BAT VK-3i preamp, and MF A300cr power amp (225 wpc). Old equipment, I know, but it sounds really good. There are two issues which I can't quite figure out.
First, I use the second output on my preamp into the line level input on the sub. I DON'T use the sub's line out into the power amp because the sound becomes very thin and unengaging. Essentially, I am running the mains full range with the sub doubling the bass. JL Audio specifically recommends that the sub's line out be connected to the power amp's inputs for a better sound. However, that's not occurring in my system. Any thoughts on why this is happening?
Second, in the configuration I use, I find that turning off the internal crossover actually brings a fuller, louder sound with more detail. Am I unknowingly biamping with the sub used this way? Seems like a waste not to use the crossover, so I have no clue as to what's going on.
I am really stumped by this, and could use your collective help. Thanks.
First, I use the second output on my preamp into the line level input on the sub. I DON'T use the sub's line out into the power amp because the sound becomes very thin and unengaging. Essentially, I am running the mains full range with the sub doubling the bass. JL Audio specifically recommends that the sub's line out be connected to the power amp's inputs for a better sound. However, that's not occurring in my system. Any thoughts on why this is happening?
Second, in the configuration I use, I find that turning off the internal crossover actually brings a fuller, louder sound with more detail. Am I unknowingly biamping with the sub used this way? Seems like a waste not to use the crossover, so I have no clue as to what's going on.
I am really stumped by this, and could use your collective help. Thanks.