Yes.
The belt driving the counter is probably perished. There is a good chance that the tire on the take-up spindle is too. The transport will eat tapes if the take-up spindle stops, so the counter belt runs off of the take up spindle.
There are replacements available through Russell Industries on the east coast and there may be replacement rubber part kits on ebay too (I’ve not checked). Its a bit of an operation to replace these parts! Its also noteworthy that while Russell probably has the parts, they don’t know which one; you may have to do some accurate measurements of the take-up spindle to sort out which tire they make works.
Since these parts are suspect, if I were you I’d replace the supply spindle tire as well as the main drive belt- all the rubber parts in the machine are likely perished at this point.
The belt driving the counter is probably perished. There is a good chance that the tire on the take-up spindle is too. The transport will eat tapes if the take-up spindle stops, so the counter belt runs off of the take up spindle.
There are replacements available through Russell Industries on the east coast and there may be replacement rubber part kits on ebay too (I’ve not checked). Its a bit of an operation to replace these parts! Its also noteworthy that while Russell probably has the parts, they don’t know which one; you may have to do some accurate measurements of the take-up spindle to sort out which tire they make works.
Since these parts are suspect, if I were you I’d replace the supply spindle tire as well as the main drive belt- all the rubber parts in the machine are likely perished at this point.