good cable for internal speaker wiring

im searching to find wire to put between cross over and driver

my speaker: http://www.canton.de/en/hifi/ergo/produkt/ergo695dc.htm

sugestion please

thenis01-31-2011 1:29am

arnettpartners Details Discussions Posts This discussion Message User 312 posts 01-31-2011 at 02:30am Copy Comment URL Report Comment Edit Delete I'm going to use magnet wire which I think is OCC wire which I can get in short lengths from Paul Speltz. But I haven't tried it yet. So it's an option but I can't tell you if I like it yet.
arnettpartners Details Discussions Posts This discussion Message User 312 posts 01-31-2011 at 11:57am Copy Comment URL Report Comment Edit Delete Why would you not use it on tweeter? Because of skin effect? You can get smaller guage from Clairvoyant Cables. Not that I'm recommending it over your suggestions, Stanwal.
arnettpartners Details Discussions Posts This discussion Message User 312 posts 01-31-2011 at 12:00pm Copy Comment URL Report Comment Edit Delete Stanwall, did you use connectors or direct solder? If you used slide connectors, where did you get them?
arnettpartners Details Discussions Posts This discussion Message User 312 posts 01-31-2011 at 07:27pm Copy Comment URL Report Comment Edit Delete Thanks, everyone.
arnettpartners Details Discussions Posts This discussion Message User 312 posts 02-02-2011 at 02:54am Copy Comment URL Report Comment Edit Delete Then I'm accidentally doing it right since my speaker cable is the same magnet wire from Paul Speltz.