If you want to perform a free short term experiment to determine if fuses can make a difference, take a small piece of heavy gauge wire or metal and bridge the fuse holder. Your equipment of course will not be protected during the test but the likelihood it fails catastrophically during the test is very small.
FUSES, Finally!?
I have been adamant about avoiding special fuses, because of the lack of empirical studies. Here is my question: What would be something not too expensive that would be a good start. I use three dual mono Audire amps (for Woofs, Mids and Tweets, and Subs, each of the six channel having four fuses. I would not not want to spend thousands, even if I could, just to experiment. My heat sinks do unplug, along with the outputs, and I could try just one channel or one amp. Paul of PS mentioned what they use, and that might eventually be a possibility, but what do you guys (and gals?) think I should do, to just to convince this ageing skeptic? Also, each channel of my amps has one single, dedicated computer chip that regulates the filling of the 4 26,000 mf caps (per channel), which might make any difference less than a design that allows a flood of electrons into the tank, presuming that might matter. DanV