I would concentrate on the mids and highs only you will not need special fuses for the bass frequencies nearly as much if at all and try to see if you can find a dealer to send you a selection of different fuses that you need and try them out it could make a real difference depending on your amp and entire system.
FUSES, Finally!?
I have been adamant about avoiding special fuses, because of the lack of empirical studies. Here is my question: What would be something not too expensive that would be a good start. I use three dual mono Audire amps (for Woofs, Mids and Tweets, and Subs, each of the six channel having four fuses. I would not not want to spend thousands, even if I could, just to experiment. My heat sinks do unplug, along with the outputs, and I could try just one channel or one amp. Paul of PS mentioned what they use, and that might eventually be a possibility, but what do you guys (and gals?) think I should do, to just to convince this ageing skeptic? Also, each channel of my amps has one single, dedicated computer chip that regulates the filling of the 4 26,000 mf caps (per channel), which might make any difference less than a design that allows a flood of electrons into the tank, presuming that might matter. DanV