2. amps-preamps
  3. 1285462037

Faint click from speakers

Hey Folks - was hoping someone here could help me out. I recently put together a system in a new house that consists of a pair of ProAc D38s driven by Cary 805Cs and a Cary 98p.

Everything sounds great except sometimes I hear very feint clicking or popping sounds from both speakers. The clicks usually start up after the system has been playing for a few hours and fully warmed up. Then the brief clicks start and continue every 4-6s coming from both speakers. They sound like the pop from dust on an analog record but very feint, and they do not get louder when I adjust the volume on the preamp. I've tried shutting off the preamp and sources, but the clicking continues. I've also put the amps into standby mode and that doesn't help either.

It seems like the source of the clicks could be the power from the wall outlets. I have everything connected to a PS Audio quintet, and I don't have any other power regulator/conditioner along the circuit.

Any ideas? Thanks in advance.
Ag insider logo xs@2xmchu168
Ag insider logo xs@2x
mchu168 OP
7 posts
 
These are some great suggestions. It's been so hectic with the move and at work that I haven't had time to do a lot of troubleshooting. Tricky part is that sometimes it takes hours for the clicking to start up.

I'm hoping that the Quintet is culprit, as it would be the cheapest fix! It better not be the amplifiers because they weigh so darn much that I would hate to be forced ship them anywhere! I'll let you guys know what I find out.
bigkidz
3,381 posts
 
I just had the same problem, it sounded like a TT was going around and the needle just keep going pop, then a few seconds later pop, etc. It turned out to be a tube. So check those first.

Happy Listening.
Ag insider logo xs@2x
mchu168 OP
7 posts
 
Well, I think I managed to isolate the problem to one amplifier, the left monoblock. After the amps are warmed up, I can hear the clicking in the left speaker, even when the left amp is in standby mode. Interestingly, when the right amplifier is on and in listen mode, I can also hear the clicking in the right speaker as well. Putting the right amp in standby eliminates the noise in the right speaker for some reason. Turning off the left amp and waiting for the power to drain out eliminates the clicking from either speakers.

I tried to swap tubes, power cords, and fuses from the left and right amps and still hear the noise when the left amp is powered on. I'll try contacting Cary next week to see if they have any ideas.
More to discover