2. speakers
  3. 1048732599

Entec L-F20 Who knows the wiring?

Hi, I recently removed the drivers for new surrounds. The problem is, I forgot how the drivers were wired. I believe they were connected in parallel, because there are 2 wires from the amp and 2 wires that connected the 2 speakers together. The 2 drivers are 4 ohm, which means that the amp would be presented with a 2 ohm load in parallel. This seems unlikely to me. Does anyone know if this amp is stable at 2, 4 or 8 ohms? Any knowledgeble advice is greatly appreciated.
ballen1
3 responses Add your response
buelligan
1 posts
 
Dear Ballen1,
I can't offer any answers about the wiring of the drivers. I used to sell Entecs about 8 years ago, but my memory isn't solid enough to give you a recommedation. I do have an Entec LF-X (the baby model) with rotted surrounds and I would be grateful to know who you went to for repair and if you're satisfied with the results.
Much obliged,
Buelligan
ballen1 OP
7 posts
 
Thanks Rhyno, That was exactly how I remembered it. I began to second guess myself when I though about the 2 ohm load.
rhyno's avatar
rhyno
649 posts
 
if i remember correctly, the set of wires from the amp goes to the top driver (w/ the servo), and then a set of jumpers goes off that driver to the lower driver.

i recall hearing that the amp is a class D switching job, so it should be able to handle 2ohm i think.

then again, my memory may be wrong.
Log in to respond
More to discover
80x80
Lawrence Audio Cello Full range speaker
80x80
GamuT Audio RS5i Speakers
FREE SHIPPING!!
80x80
Revel Revel Gem 2 Stand-mount Speakers