Dynaudio Stand 6 and Contour 1.4' installation

Are there threaded inserts in the bottom of the speaker itself?

I'm not clear on something. There's the speaker itself. Then, at the bottom of the speaker is a wood base. Are you trying to attach the wood base to the bottom of the speaker, or are you trying to attach the top metal plate of the stand to the bottom of the speaker? And when I say the bottom of the speaker, I mean the speaker with the wood base already connected to the speaker.

Jaxwired,

What's so complex about the Dynaudio Stand 6? The instructions are pretty clear and straightforward. That doesn't mean the OP couldn't have made some type of mistake, but I just don't see the complexity.

Benmcosker,

I think I know what the problem is, but I can't say until I you give me an answer to my last post.

You should have 2 sets of spikes that came with the Stand 6. The bigger ones go on the on the bottom of the stand by the floor. The smaller spikes go in the top plate. Thread them into the top plate so that they are pointing up. The speaker sits on the spikes and don't get bolted to the stand.