Dunlavy resurrection?

If you want to know what's special about Dunlavy speakers, click on the link and goto the bottom of the page to the "waterfall" plot.
This is the cleanest I've seen (a late-gen Wilson Watt had a similarly clean graph albiet with a lower amplitude).
Another element of this speaker's sound is the tight (hand adjusted) matching of driver/crossover components. From Stereophile: "Pair matching: better than ±0.5dB up to 15kHz." Comparing the response of both test speakers.
Amazing.
Dunlavy Audio Laboratories SC-IV loudspeaker Measurements | Stereophile.com

Vinestreet,  I built a box with a downfiring 
Scanspeak 25w8565-00 to set
my Dunlavy SM-1’s on.
I am using a simple 14.5mH coil for crossover currently-I am surprised how good it sounds.
I am using them as surrounds and Dirac Live mops up what I lack in know how.
I have played with a Zobel to flatten impedance a bit but I honestly did t notice much of a difference....
Any tips?

I'm sure it sounds pretty good.  You are dipping below 3 ohms likely at times below 90hz doing it that way so you should have an amp that is happy with that.  If they are surrounds do you really need the extra bass anyway?

vine, while I've heard different DAL models I don't know as much about them as the Duntechs.  My impression was that John cut some corners in producing his DAL models to keep prices as competitive as possible.  With a casual glance the comparable models between the two companies looked very much alike, but there were important differences.

The two best examples were drivers and cabinet design.  I believe the DAL utilized Vifa and Scanspeak.  Those may be less expensive than the Dynaudio drivers in Duntechs.  And the cabinets for DAL had straight side panels, rather than step back sides for the mids and tweeter (even with heavy felt surrounds, less side reflections).  I don't know about internal bracing in the DALs but my Duntechs had separate compartments for each driver and all were heavily braced.  Each Princess weighed at least 180 pounds.  What does the sibling DAL SC-IV/IVa weigh?

For all that, while I never heard comparable models side by side, I always thought the DAL models sounded very good.  I was just a bit prejudiced that my Duntechs performed a little better. ;^)

@vinestreeti would like to use in a separate system eventually.