If worried,wire them in series>> Out to L200 "+",out the "-" to the L300 "+","-" back to the Arcam.This should present the Arcam with a 6-8 ohm load.
Driving 4 ohm speakers
I have been given a pair of ADS L200 and a pair of ADS L300 speakers. I am planning to take them to my office, which is about 12x16. I have an old Arcam Alpha 9 amp that I will use there.
Forgive this sophomoric question. The Arcam is rated to drive one set of 4 ohm speakers, or two sets of 8 ohm. The ADS are 4 ohm. My question is, can I drive both with this amp at low volumes? In this small space, I can't see cranking up the volume very high. Obviously, I don't want to burn out either my amp or my speakers.
Thanks for your advice.
Forgive this sophomoric question. The Arcam is rated to drive one set of 4 ohm speakers, or two sets of 8 ohm. The ADS are 4 ohm. My question is, can I drive both with this amp at low volumes? In this small space, I can't see cranking up the volume very high. Obviously, I don't want to burn out either my amp or my speakers.
Thanks for your advice.