Doshi Jhor 90W monoblocks


Has anyone had experience with a Dohsi John 90W amp? I am looking to use them with my SonUs Faber Olympia IIIs. Not much information on the web. 

Basic Specs
EL34 Pentode output tubes – 90 watts per channel
Input Impedance: 75k ohms
Sensitivity: .775v rms for full power
Feedback: 22db
Output Impedance: 4 ohms
Output Power: 90 w
 
Here are the specs for my speakers
FREQUENCY RESPONSE
35 Hz – 30.000 Hz, tuning port included.
SENSITIVITY
90 dB SPL (2.83 V/1m). NOMINAL
IMPEDANCE
4 ohm.
SUGGESTED AMPLIFIER POWER OUTPUT
50W – 300W, without clipping.
LONG-TERM MAXIMUM INPUT VOLTAGE (IEC-268-5)
22V rms.


Room 13 X 15 feet 195 sq feet
ceiling 7 feet
Total volume = 1365 feet



Source:     MiniMac 2014 3.0GHZ I7 16 GB 4TB SSD as NAS
Software:     Roon, Tidal
DAC:       PS Audio Directstream
PreAmp:     As phono stage Moving Coil Anthem Pre 1
PreAmp:   Doge Clarity preamp used as line stage and MM phono stage
Turntable:     VPI Aries Limited Edition
Speakers:   SonUs Faber Olympia III
Sub:       SVS SB13-Ultra
Power:     Furman Elite-15 PFi
Cart:             Denon MC DL-103R
SUT:       Bob’s Devices SKY

I am a newbie. Any advice would be appreciated. Thanks!

chazark123

Showing 1 response by gdnrbob

If you want to try tubes, I would look at Atma-Sphere.
But, if you want to try the Doshi, then you could get some rca-xlr convertors from Jensen for about $300. I spoke with Ralph (Atma-Sphere) and he said they shouldn't do much to the sound- I was thinking of using them when I bought his amps). 
I would then look for a pair of Zero Autoformers to help with the 4 ohm response of your speakers.
Hopefully, Ralph will see this post and give you the most accurate information.
Bob