In most instances the DAC has sufficient gain and sufficiently low impedance to drive the power amp through a pot. InnuOS has the server recommended at 100% which has nothing to do with the question. It is the DAC’s output section that matters. BTW: absent serious but rare impedance mismatches all that a pre adds is more distortion/ colouring.
Do Audiophiles usually keep the gain of the digital source at around 80%?
My setup is:
A8 Eversolor DAC and streamer
McIntosh C12000 preamp
REL sub 810
Focal Sopra n1 speakers.
861 Moon amp
I keep my McIntosh preamp usually between 50-60% volume. Any higher would make the sound thin like.
For the Eversolo streamer (which I am enjoying quite a bit for the money), I keep between 75% -85% max gain. With older songs that are recorded at lower volume, I have it at 85%. But with songs that are recorded louders (mostly newer songs) it would cause some/slight clipping at that level so I to have lower the gain to about 75% max gain.
I saw that there was a max volume throughput option on the Eversolo, but when I try that I can’t really get the system as loud as I want it without clipping and distortion setting in early.
Is this normal for Audiophiles to keep the gain on the digital signal about 80%?
Wasn’t sure if this should go into digital forums or preamps since both are used here, so I posted here.