I went a different route. I used the motor housing, platter and bearing from a VPI TNT 4 and built my own plinth. I also used a 300 RPM Hurst motor and VPI's one speed pulley. Feet are also VPI for now . The plinth is 21"x16" and 1 1/2" thick.
DIY TT
I am looking at the Denon DP-3000, which appears like it might be able to slide out and mount into a homemade base?
Basically I am looking for a dual arm setup.
Also my existing TT only takes 1 arm, and it is limited in which arms lengths it can support.
Or are there other drive units which might be better suited to such a scheme?