2. cables
  3. 1098914488

DIY Speaker Cable Canare 4s11 Home Depot Lowes

Looking at this for improved sound on second system. I have no background in electronics so "simpleton" answers appreciated and forgiveness for simpleton questions requested in advance!

1. If I buy Canare 4s11 should I braid this? If so, what kind of configuration is preferable?

2. If braided, how should the strands be terminated (is one used as a ground, etc.?)?

3. If I go with HD or Lowe's extension cord cable, any recommendations between 14, 12, 10, and 6 awg?

4. If I go with HD or Lowe's extension cord cable, do I just (stupid question here) have them terminated as is with two runs of cord in a single termination for each channel (i.e. I get 4x the length of finished cable I need for each speaker)?

5. On the extension cord cable, if there are 4 internal wires do I use one as a ground? Leave 2 'hanging'? Have all 4 soldered to the spade?

Thanks for any help or resources. I've looked at some DIY threads but haven't found one that addresses these specific questions or answers them in a "this is the generally preferred way to do this" fashion.
girardian

Showing 1 response by vegasears

vegasears
1,173 posts
 
Not the answers you are looking for but...

I went to Lowes and picked up some multi stranded THHN 14 AWG wire. I secured the wire together and wrapped it around at tree in the backyard then placed the other ends in a drill motor. I stretched out the wire and twisted it tightly with the drill motor. The twisting adds natural shielding and looks cool too. The project was cheap, easy and fast. As for the sound, you will have to be the judge.

Have Fun
Allan
More to discover