DIY Replacing Components in Crossovers


I have a couple pair of old speakers that I'm thinking about tinkering around with by replacing existing capacitors and/or resistors with different brands just to get a taste of how different higher quality parts affect the speaker's sound. I don't have any interest in redesigning the crossover networks, only to replace existing parts with better quality parts with the same values to see what kind of results I get. Soldering and the mechanics of replacing the parts isn't an issue for me but I just don't have much experience with the sonics of individual parts. Have any of you done this before? What has worked for you? All things being equal, do you hear much difference replacing crossover parts with better quality components? Any stories to tell? Thanks for looking.

 

arch2

Showing 1 response by grannyring

Some say they don’t matter or matter as much. I find they really do and are in fact in the signal path. If one doubts that, then remove the parallel cap and listen 🤓. Yes, you can save money here and not get the very best. If it’s an electrolytic, then replace as it may have dried out over time.

 

Don’t forget resistors.  Some nice $5-$7 Mills MRAs will be a very nice sonic improvement for relatively little money.